Hypershift Assembly And Calibration Last Updated: 10/17/2026 View fullsize 0. Grab printed parts and install heat set inserts View fullsize 1. Install power button, brass bearings, wheel return lever, and wheel return spring View fullsize 3. Tighten down trigger View fullsize 2. Loosely tighten down motherboard bolts View fullsize 5. Tighten down motherboard bolts View fullsize 4. Ensure that trigger moves freely View fullsize 6. Place remote wheel in brass sleeve bushing View fullsize 7. Place M2 bolt in post hole View fullsize 8. Place brass sleeve in bottom shell View fullsize 9. Press bottom in place and put exterior bolts in position View fullsize 10. Tighten exterior bolts View fullsize 11. Press power button to ensure good actuation View fullsize 12. Power on and connect board. Buy Hypershift
